ZP3 Dev Interface Board

Meeting Notes

Attending: Darwin Clark Jack Greenwood Aidan Bowers (Deactivated) Ethan Abraham Christopher Chung
Agenda
- Desired features of ZP3 interface board Rev. 1

Proposed (EE)	Proposed (FW)	Final
Every IO pin (~45) broken out Header: 2.54mm standard male pins (female?) Make sure to get 3v3 Make sure to get 5v multiple NOT VBat Pad beside header for oscope		Every IO pin (~45) broken out Header: 2.54mm standard male pins (female?) Make sure to get 3v3 Make sure to get 5v Multiple NOT VBat Pad beside header for oscope For PWM pins, break some (all?) out in a servo standard (signal power ground) Group UART with power, TX, RX, ground Very explitily labeled groups No power + gnd for SPI and I2C, just the data pins LEDS to unused GPIOs
Power and Interlock LED	Darwin Clark Will look into how possible this is
LEDs or indicator on all comm lines (Data lines of UARTs, I2C, SPI, PWM) ++
MicroSD card pins		MicroSD card pins break out
Pot, selectibly tied to analog input pin via header
	Easily accessable ground (screwholes or on isolated male pin)	Easily accessable ground (screwholes or on isolated male pin)
		In general making sure that things arn’t clumped together such that one is touching pads together

Flight Board niceities

Darwin Clark (fixture this out) Putting simulator connector for simulator board on both flight and dev board
Christopher Chung Figure out weather or not timer pins are bidirectional and which ones are used for PPM on ZP3.0 sch

Rev n Features

Instructions: If you have ideas for a feature that should be present on a future revision of ANY interface board, list them here and what board it is applicable too (E.G rev 2 of dev interface, flight interface, ect.)

Idea 1
Ect…