General Goals:
Update old Frosted Flakes block diagram to include all devices & sensors for competition\
Power architecture (where power comes from + where does it go, for every single power consuming device)
If possible have max. and nominal power consumption
Mechanical layout & positions of the devices (general locations & mounts for all devices)
Task 1: Updating Old Block Diagram
Following up with SysInt and all project owners to confirm the purpose & use of each sensor, how it’s going to be used
Indicate how everything is connected
What type of connector is needed for each harness must be indicated on block diagram at each connection point
Starting points:
Michael Botros's list of every single device from the System Architecture doc (pasted above)
Discord RFC for sensors & peripherals (https://discord.com/channels/776618956638388305/1082868951656173609)
Look up each product’s connection outputs
Task 2: Power Architecture
Define all power consuming devices and all power supplies/voltage rails available
Get the max. and nominal power consumption for these devices
Figure out what voltages to use for the architecture, figure out where each device will get its power from
Starting point:
List of all
Task 3: Mechanical Layout & Component Locations
Roughly define where all components will go
Work with onsite and mechanical people to