Big Project | Project | Project Manager |
|---|---|---|
Houston | Electronics Mounts |
Task Description
Need a 360 lidar mount for Houston
Constraints
To be written by the Project Manager. All constraints should be their own row of the table, if a constraint is removed it should be crossed out but left in the table. The append date is when the constraint was last updated (update this when constraints are removed!) DELETE THESE INSTRUCTIONS BEFORE PUBLISHING
Constraints | Written By | Append Date |
|---|---|---|
Lidar should remain as free as possible of FOD / kickback on takeoff | 2023/11/25 | |
Lidar should not have obstructions around it in 360 FOV. | 2023/11/25 | |
Use the provided mounting holes | 2023/11/25 | |
Lidar to be mounted either right side up or upside down | 2023/11/25 | |
Communication cable must be accessible either by removing the lidar or through open area below | 2023/11/25 | |
Beam width can be assumed to be 3 degrees at absolute worst case. Nominally <0.5 degrees from spec sheet | 2023/11/25 |
Relevant Contacts
Subteam | Contact | Contact Description |
|---|---|---|
Tech director? | Gave constraints |
Assignees
Assignee | Asana Task | Date |
|---|---|---|
2023/11/25 |
Task Progression/Updates
Author: Alison Thompson Date: 2023/11/25
INITIAL UPDATE
Lidar to be mounted on raised platform over pixhawk in the middle of the drone. Uses existing threaded M3 holes on Houston and M3 holes for the mount to the sensor. Potential for GPS to be in the FOV, attempting to make it in the Lidar’s blindspot. If not possible Nathan Green is looking into ignoring a range in software. Due to the height of GPS it will be very sketchy to mount Lidar any higher than it.
