Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

Online

Remaining Items Big Picture:

  1. Schematic, footprints and component selection are done

  2. Routing needs to be done and general component placements

  3. Follow up with Daniel on the comments he left in Altium

Component Placement:

a. Confirm if pads will be used over XT90s

If this is the case then determine the size of the power pads and where they will be located.

b. Confirm if both sides of the board can be used especially given the 30x30 mounting requirements.

Additions:

  1. Given the possibility of pads being used instead of XT90s, this means that there is no mechanical reverse polarity protection. In this case, will reverse polarity protection circuit be implemented?

  2. Would be nice to have status indicator LEDs

  3. Board cooling? Engineering analysis needs to be done to determine if the board needs to be cooled.

Action Item: Taim Al-Dabbagh Steven Wang Will come up with a plan of attack and give an update during EE meeting on Thursday, September 28, 2023.

  • No labels