Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 175 Next »

Below is the essential list of items to bring to a flight test:

  • Hex

    • Frame w/everything mounted
    • Propellers and screws
    • Egg Grabber

    • Egg Dropper

    • Extra screws and nuts
    • Allen keys
  • Batteries

    • 2, 6-cell batteries
    • 1, 3 cell transmitter battery (for Taranis)
    • 2 Turnigy Battery chargers
    • 3 go pro batteries
    • Go pro charger
    • Battery Level Checker

  • Electrical

    • Multimeter
    • Wire (24AWG stranded, 22AWG solid)
    • Connector cases

  • Tapes

    • Electrical tape
    • Masking tape
    • Duct tape (clear)
    • Duct tape

  • Cables

    • PWM Cables
    • 2 Y-harness battery adapters
    • Extension cord
    • HDMI cables (for DJI)

  • Autopilot

    • 2x Picpilot boards
    • 2x GPS modules
    • 3x Xbee's (2 plane, 1 ground station)
    • Airspeed sensor and tubes (with voltage divider if needed)
    • 2x Programmer with cables
    • Dragonlink UHF (receiver, transmitter + antennas)
    • OrangeRX UHF (receiver, transmitter + antennas)
    • Taranis RC Controller (with charger)
    • Power Distribution cable/board

  • Data Relay

    • Laptop and charger (WARG)
    • Data Relay Case
    • Router, Ethernet switch
    • OrangePI
    • Power bar
    • Tracking Antenna

  • Gimbal

    • GoPro
    • IMU + cable
    • Controller board

  • Other

    • DJI Light bridge - Ground Station (2 antennae,  microHDMI adapter)
    • DJI Light bridge charger
    • DJI Light bridge - Airplane Module
    • Electrical Toolbox
    • Mechanical Toolbox
    • Walkie Talkie
  • For competition:

    • Additional plane body

    • Geese

    • Power supply (BK)

    • Super Computer

    • Soldering Iron, Solder

    • Monitors (3)

    •  
  • No labels