Below is the essential list of items to bring to a flight test:
Plane
- Wings and 4 screws
- Plane Body
2 Spars (for wings)
Propeller, washer and nut
- Wrench (for propeller)
Batteries
- 4, 4 cell batteries
- 2, 6 cell batteries
- 1, 3 cell battery
- 1, 3 cell transmitter battery (for Taranis)
- 2 Turnigy Battery chargers
- 3 go pro batteries
- Go pro charger
- Battery Level Checker
Electrical
- Multimeter
- Wire (24AWG stranded, 22AWG solid)
- Connector cases
Tapes
- Electrical tape
- Masking tape
- Duct tape (clear)
- Duct tape
Cables
- PWM Cables
- 2 Y-harness battery adapters
- Extension cord
- HDMI cables (for DJI)
Autopilot
- 2x Picpilot boards
- 2x GPS modules
- 3x Xbee's (2 plane, 1 ground station)
- Airspeed sensor and tubes (with voltage divider if needed)
- 2x Programmer with cables
- Dragonlink UHF (receiver, transmitter + antennas)
- OrangeRX UHF (receiver, transmitter + antennas)
- Taranis RC Controller (with charger)
- Power Distribution cable/board
Data Relay
- Laptop and charger (WARG)
- Data Relay Case
- Router, Ethernet switch
- OrangePI
- Power bar
- Tracking Antenna
Gimbal
- GoPro
- IMU + cable
- Controller board
Other
- DJI Light bridge - Ground Station (2 antennae, microHDMI adapter)
- DJI Light bridge charger
- DJI Light bridge - Airplane Module
- Electrical Toolbox
- Mechanical Toolbox
- Walkie Talkie
For competition:
Additional plane body
Geese
Power supply (BK)
Super Computer
Soldering Iron, Solder
Minitor