6s-5V Buck Converter @ 6A Max (fsw = 250kHz)

Review 1

Open

• Change polygon property setting to “Pour Over All Same Net Objects”

• Clean up polygons (just for my OCD, but it’s good practice!)

• You can probably shift the IC and all the small components around it down and to the right (it will allow for GND to connect cleaner once you move the input and output decoupling capacitors around a bit)

• For this, use a thicker trace (0.254mm to 0.381mm) to connect big VBAT polygon to the VIN pin

Open

• Make HO and SW traces as adjacent as possible

• Consider rotating inductor to make current flow from SW to 5V as clean as possible

• Increase trace sizes for HB, VCC, VCCX

• Round the edges of the PCB with same curves as mine

• Try to adjust input and output capacitors a bit more optimally

• Move bulk capacitor closer to the board

• Gap between RAMP and SS passives

• EN resistor can be moved closer to IC

• Make sure there is a cutout for the CSG current sense trace on the bottom layer as well (otherwise GND will connect to it, even though it is technically also ground

Review 2

• Make sure there’s no sharp angle in traces like there^ can create acid traps

• Make CS polygon pour just over the pad (down to just the edge of the pad)

• It’s fine that the cutout extends over the CS pin too, but it’s not necessary, you can bring the polygon up

• Increase thermal relief width for VBAT polygon

• Increase LO trace width