FEA Report Template

Objective

[Briefly describe the goal of the simulation. This report is valid for stress and thermal simulations. Delete this before publishing.]

Simulation Setup

Assumptions and Preliminary Calculations

  • [Include any hand calculations. Delete this before publishing.]

  • [What assumptions are you making in this simulation? I.e. linear material behavior, ignoring friction/other forces, if simulating 3D printed material how are you modifying the geometry/material properties?]

  • [insert the material property if you have modified it, include links if you obtained them from a source]

Applied Loads

[Insert screenshots showing where loads are applied on the part, forces in Newtons/kN Delete this before publishing.]

  • [If force magnitude is not visible in the image, mention it here]

Fixtures

[Insert screenshots showing where fixtures are applied. Make sure the type of fixture is visible in the image and if not, mention it in the caption]

Mesh

[Insert screenshots of the mesh. Ideally you want to perform multiple trials and improve mesh refinement to see when the solution stops changing as the mesh size increases].

Trial #

Mesh Parameters

Screenshot

Trial #

Mesh Parameters

Screenshot

1

Element size:

# of nodes:

 

2

Element size:

# of nodes:

 

3

Element size:

# of nodes:

 

[If local mesh refinement is used, include pictures that show where the refinement is added]

Results

Trial #

Maximum Stress (MPa)

Screenshot

Trial #

Maximum Stress (MPa)

Screenshot

1

 

 

2

 

 

3

 

 

Could also include minimum safety factor.

[Make sure to capture the point/points where the maximum stress occurs]

 

Conclusion

[Summarize your findings. Bullet points are fine]

  • [Provide any recommendations as to how the design can be improved. I.e. adding cutouts where there is extremely low stress distribution]