CV Camera Mount
- Smile Khatri
Big Project | Project | Project Manager |
|---|---|---|
Houston | CV Camera Mount | @Smile Khatri |
Task Description
Design a mount that simplifies mounting the CV camera to the Houston landing gear plate. Refer to Houston Landing Gear V2 - Mechanical - WARG (atlassian.net) for the landing gear design.
CV camera documentation: $200 CV Camera - Autonomy - WARG (atlassian.net)
Constraints
Constraints | Written By | Append Date |
|---|---|---|
Mounting holes are spaced 28mm x 28mm apart. | @Smile Khatri | 2024-07-06 |
Enough clearance between PCB components and the mount so the board is not damaged. This can be done through spacers. | @Smile Khatri | 2024-07-06 |
To be 3D printed. |
|
|
Relevant Contacts
Subteam | Contact | Contact Description |
|---|---|---|
Mechanical | @Smile Khatri |
|
Assignees
Assignee | Asana Task | Date |
|---|---|---|
| link to asana task assigned | Date assigned |
Task Progression/Updates
Name: Smile Khatri Date: July 22, 2024
The cutout is 5mm by 12.2mm. The width of the connector is exactly around 5mm, probably make the cutout larger because 3D prints shrink.
I would do around 14mm x 7mm, it is safer to make the cutout larger. Also depending on the accuracy of the position of the cutout, the connector may or may not fit so a larger cutout is nice.
Also the mounting holes are 2mm, but the datasheet shows 2.5mm holes, so probably use a larger hole.