2024-01-25 EE Meeting

Meeting times:

  • EE Meeting: Thursdays 8 PM EST E5 1006

  • Leads Meeting: Monday 8 PM EST E5 2004

  • Team Competition Aircraft Sync: Monday 7 PM EST online

 

Attendance:

In person

Online

  • @Jerry Tian

  • Ian Van den Steen

  • @Taim Al-Dabbagh

 

  • @Neel Patel

  • @Anthony Zhelnakov

  • @Mostafa Hussein

  • @Parker Lawrence-Valeriani

  • @Ryan Scomazzon

  • Ishman

  • @Rayyan Mahmood

  • Cory

 

Updates this week!

Announcements

 

Active PCB Projects

High Current Power Module (Taim)

  • @Taim Al-Dabbagh

Taim is busy, no progress

12S ESC (Ethan, Chris)

  • @Ethan Abraham @Christopher Chung

Hand this off to Mena?

6S ESC (Rayyan, Mostafa)

  • @Rayyan Mahmood @Mostafa Hussein

  • Rayyan: MOSFET selected - need review on it and also need a quick rundown of altium365

  • Mostafa: Completed Buck Comparison + Decision Matrix; updating confluence with results and will share link after meeting.

old comp

LED Controller (Neel, Parker)

  • @Neel Patel @Parker Lawrence-Valeriani

  • adding new header for the testpoints

  • pull-up resistor for IC reset pin & external clock not needed, see justification on confluence

  • Neel will backup this weekend

PDB (Tom)

  • @Tom Chiu

 

Tracking Antenna (Nolan, Hardy, Michael)

  • @Nolan Haines @Hardy Yu @Michael Botros

  • Not happennning for competition

  • Daniel has opinion about the layout, there will be a meeting this weekend

12S Servo Module (Jerry)

  • @Jerry Tian

  • Board design & review is complete, it’s gonna be ordered with LED controller and RFD900 breakout

ZP3 Rework (Anthony, Ryan)

  • @Anthony Zhelnakov @Ryan Scomazzon

  • All connectors updated to JST

  • Connector routing done !!

  • Decided to not go with an IMU

    • EFS don’t really it

    • have to re-do zp3 main board to route pins up to the interface board for IMU

Capacitor Analysis for Drone (Anthony)

  • @Anthony Zhelnakov

  • no progress

CAN Interface Board (Hardy)

  • @Hardy Yu

  • EFS (Hardy) will be doing project scope and selecting ic and interface components so they can start programming

  • EE will select other passive components and do board layout

Flight Test