2/7/2022 Meeting Minutes

@Kevin Li

• Filed a few reimbursements

• Transferred components for ZP2.0, Gimbal, and FW Training to WARG bay

• PDB Rev 2.0

• Bootcamp

• Helping Darwin, Akshat, Ethan, Jatin, and Kevin Song with power distribution and motor controller

@Daniel Puratich (Unlicensed)

• Hot air station sourcing

• Testing Firmware

• Block Diagram

@Kiran Surendran

@Jason Skells

• Got the motor controller ready for design review

• Fixing issues brought up in the design review

@Muhammad Tanveer

• Finished temp sensing, finalized sourcing (other than headers)

• Finalize header sourcing

• Clean up schematic for design review

@Darwin Clark

• Soldered 90% of components on FWTraining (ADC, Headers, ect.)

• Got through ~10 more pages in Buck Converter Datasheet

• Solder remaining components on FWTraining

  • Start to verify board? Reach out to Gordon?

• Finish Buck converter datasheet

• Create + Check-in new Altium project

• Source components for buck converter

• Finish schematic

@Seungmin Hong

• Select viable batter connector

• Schematic design review

@Ethan Abraham

• Created spreadsheet and gone through LM25116 formulas with example design given

• Tweak independent variables to minimize ripple voltage, power losses, etc.

• Choose values based on part availability

• Finish schematic and sourcing for next Monday

@Jatin Mehta

• Started checking out DigiKey gate drivers

• Read through more datasheets

• Create spreadsheet with possible components for motor controller

@Kevin Song

@Neel Bullywon