Fuselage Design

 

Big Project

Project

Project Manager

Big Project

Project

Project Manager

2024 Fixed Wing

Fuselage

@Alison Thompson

Task Description

This will start mainly as researching fuselage shapes and once we have a few we want to try, it will become the CAD of how we want to implement this and mount it to our airframe.

Constraints

Constraints

Written By

Append Date

Constraints

Written By

Append Date

Made out of foam (at least for now. If there is a better way to make it, we will consider!)

@Smile Khatri

 

Sufficient space at the nose to mount front motor

AT3530 3D Fixed Wing Airplane Long Shaft Brushless Motor -KV580_AT Series_Motors_VTOL/Fixed Wing Power_T-MOTOR Official Store - UAV Power System, Robot Power System, Model Power System (tmotor.com)

@Smile Khatri

 

Assignees

Assignee

Asana Task

Date

Assignee

Asana Task

Date

@Calum Chisholm

 

August 14, 2024

@Victor Sun

 

Sep 21, 2024

Task Progression/Updates

Calum Chisholm: 2024/08/27

UPDATE TITLE

Wing Span = 23.62 inches x 2 = 47.24

Fuselage Design should be around 75% of the wing span = 35.43 inches

 

Calum: 2024/09/20

Fuselage Length should be 75% of the wingspan

  • According to the assembly the wingspan is 1199.896mm long so the fuselage should be 899.922 mm in total length

  • A fuselage is divided into 3 sections: F1, F2, F3

    • F1 = The start of the leading edge of the wing and should be 20% of the fuselage length so 179.9844 mm in length

    • F2 = The tail length from wing trailing edge to leading edge of horizontal stab about 40% so 359.9688mm

  • The fuselage height should be 10 - 15% of the fuselage length so 89.9922 mm high

I am not sure if were are following these guidelines though

 

image-20240920-205429.png

 

Author: @Calum Chisholm Date: October 5th 2024

image-20241005-172635.png
Side View
  • Added the fuselage design into the main assembly of the plane. Its mated to the center of the plane with each of its “planes” parallel so it should be symmetric with the frames axis.

  • The Fuselage is a sketch in the x-y plane that is extruded so if any changes to the frame are made then this “sketch3” can be adjusted to accommodate these changes

  • Cutouts for the camera and the front motor mount have been made but other cuts should be made for the landing gear

  • At the moment the fuselage is quite “blocky” due to manufacturing constraints and the use of foam boards further ideas can be explored to make the fuselage more aerodynamic

 

 

@Calum Chisholm 10/10/2024

  • Updated fuselage so it accommodates the new wing spacing, also created a cutout for the landing gear

  • It seems like the frame/body is a bit wider than the wing spacing which is creating that interference seen below

  • In terms of mounting the fuselage onto the frame I was thinking that we could use the pre-existing mounting holes for the wing and the body highlighted in my yellow screen shot