Tracking Antenna Groundside Hardware

There shall be at least 2 tracking antennas, each operating at one frequency (900MHz & 1.3GHz respectively).

There will be the following hardware components:

1 rfd900x https://store.rfdesign.com.au/rfd-900x-modem/

1 1.3ghz vrx RMRC 900MHz-1.3Ghz High Performance Receiver with Custom Tuner

1 RCA splitter (1 to 2 or 1 to 4) https://www.amazon.ca/axGear-Video-Audio-Splitter-Screen/dp/B01MFAJKEM/

(potentially) 1 5.8GHz VTX Eachine TS5828L 600mW 5.8Ghz 40CH Mini FPV Transmitter VTX with LED Display For Tiny RC Drone

(potentially) 1 5.8GHz VRX Monitor Eachine LCD5802D 5802 5.8G 40CH 7 Inch FPV Monitor with DVR Build-in Battery for RC Drone Airplane Long Range

(potentially) 5.8GHz Goggles (we’ll just count these separately since they should just work with a 5.8 relay)

1 computer w/main monitor

battery power for rc-link & video

a nucleo?, maybe with external power distribution for the servos.

900 MHz Antenna System
1 patch antenna: X-AIR 900 - TrueRC Canada

1 omni antenna: https://www.truerc.ca/shop/900mhz-3/transmitter-900mhz-3/singularity-868

? servos

1.3 GHz Antenna System

1 patch antenna: https://www.truerc.ca/shop/1-3ghz-3/receiver-long-range-1-3ghz-3/x-air-1-3-new

1 notch filter: https://www.team-blacksheep.com/products/prod:notch_filter_1g2

? servos

** the further apart the antennas, the better **

Also, ideally, all the electronics are inside the case…with a distribution panel for all our connectors

Similarily, if there’s terminated connectors on the stand that we can just clip into, probably makes setup/takedown easier. (servos & antennas)