Pre-Takeoff System Checks

Barbies are secured with seatbelts

Cargo is secured with rubber bands

Ramp is closed properly, both Velcro are aligned

Cabin skeleton is not loose/cabin won’t fall off mid-flight

Registration #, WARG logo, and Canada flag are on the cabin frame

No loose or dangling screws/mounts/PCB

Carbon fiber arms are sturdy and tight through the arm clamping blocks. Tighten the clamp if an arm is too loose

Carbon fiber arms do not rotate about the center block

No loose bolts on the landing gear T-joint

OFS is attached securely to its mount and the mount is not loose. Mount cannot rotate about the arm and it does not shift along the arm

FPV cameras are mounted tight and do not pitch easily

Nothing obstructing the FOV of the FPV cameras

Sensors connected to Pixhawk - check if any sensors are popped out

VTX antenna is taped sufficiently and does not come in contact with the propeller

ELRS antennas are exposed and easily accessible (not trapped between battery covers)

ELRS ep2 is taped securely

All 4 batteries fully connected

Batteries are Velcroed properly and do not shift

XT90 path fully connected

Motor phases follow the pattern as labelled

Prop direction inward and props mounted correctly

Battery harnesses are strong

Motor bullets fully inserted

GPS hold to arm safety switch completed and confirmed from ground station

Wires secured away from propellers

Battery covers are fully clipped on

Flight Tests