| | |
---|
@Kevin Li | | Create footprint for the switching diode Validate error amplifier compensation network passive values Validate EN pin configuration Add SPDT switch to EN pin, input bulk capacitor, screw terminals for loads and motors Add LED indicators Purchase hot air reflow station with other components
|
@Daniel Puratich (Unlicensed) | | |
@Kiran Surendran | | |
@Jason Skells | | Need to order MOSFETS My library was a little buggy, so I need to connect the footprints and make some for components Need to talk to firmware team and get someone to write the motor controller code (stm nucleo) when rev 1 motor controller is finished, we will likely be selecting mcu
|
@Muhammad Tanveer | | |
@Darwin Clark | Finished placement with the help of Kevin Wrote a basic confluence page Re-sourced pot Done 1.5 passes on routing
| |
@Seungmin Hong | | Complete gimbal page with detailed electrical and component specification Create new block diagram with updated gimbal logic Create gerber files for gimbal PCB
|
@Ethan Abraham | | |
 |  |  |