LTE Mount
- Nathan Green
- Sohee Yoon
The LTE module is a Raspberry Pi 4 with a Waveshare 21707 LTE hat. It is used to communicate with the flight controller over mobile networks.
Big Project | Project | Project Manager |
|---|---|---|
2024 Comp Drone | Electronics Mounts | @Nathan Green |
Task Description
A mount which securely holds the Pi with the hat and fits our 30x30mm hole pattern is needed.
Constraints
Constraints | Written By | Append Date |
|---|---|---|
USB-C Port & USB-A ports on the Pi must be exposed | @Nathan Green | 2023/10/05 |
Pi is securely held in place | @Nathan Green | 2023/10/05 |
Fits 30x30mm hole pattern | @Nathan Green | 2023/10/05 |
Pi cannot touch the carbon fibre to avoid shorts | @Nathan Green | 2023/10/05 |
Prioritise light weight | @Nathan Green | 2023/10/05 |
Note that there is no requirement for the mount to fully enclose the Pi and the hat, as the top will be covered and the module operates at low voltage (5V).
Assignees
Assignee | Asana Task | Date |
|---|---|---|
@Sohee Yoon | 2023/10/05 |
Task Progression/Updates
Author: @Sohee Yoon Date: 2023/10/10
INITIAL IDEAS
Design a mount designed like a box with an open lid. The bottom consists of cut patterns to reduce weight. Idea was based off of this image:
CAD result:
Note: Little adjustments have been made after 3D printing a draft.