2023-11-23 EE Meeting
General Team Status/Schedule:
Meeting times:
EE Meeting: Thursdays 9 PM EST E5 1006
Leads Meeting: Wednesday 9 PM EST E5 1006
Team Competition Aircraft Sync: Tuesday 9 PM
Attendance:
Online | In person |
---|---|
|
|
Quick Links:
Updates this week!
Admin:
Aircraft sync happens every Tuesday at 9pm.
EE members are encouraged to drop in and listen.
Fall open house this weekend.
Houston flight test on Sunday
Active PCB Projects
High Current Power Module (Taim, Steven)
@Taim Al-Dabbagh @Steven Wang
Layout is done, waiting for EE leads to review (leave comments).
Mike left comments
Daniel
Ethan (time permitting)
Fact check XT90 current limit: supports up 90A continuous and 120A bursts. We’ve tested higher on ICARUS.
Will proceed to layout after.
12S ESC (Ethan, Chris)
@Ethan Abraham @Christopher Chung
After finals, too busy at the moment.
Decent progress achieved.
6S ESC (Rayyan, Mostafa)
@Rayyan Mahmood @Mostafa Hussein
Mostafa: No updates this week
LED Controller (Neel, Parker)
@Neel Patel @Parker Lawrence-Valeriani
Neel will come into bay on the weekend, concerns about brightness for LEDs. Top draw of red tool box
Circuit design has been started, aiming to be done by Wednesday.
ELRS Gemini (Michael, Farris)
@Michael Botros @Farris Matar
No updates from EE, seems to be working.
Drone Battery PCB (Farris)
@Farris Matar
Confirmed dropped, not feasible?
PDB (Tom)
@Tom Chiu
Caught up with course end-of-term projects and school, have not made much progress since last meeting.
Sorry @Daniel Puratich , very likely the case that I will not be meeting the end-of-term deadline to guarantee the testing of the PDB. When would you be free to discuss next steps, because I would have a lot more time during my co-op to grind away at it unlike my last co-op where I had a lot of work and reading to do outside of work.
I will still be working on it through exams and winter break.
Would be nice to have but not required for this competition season.
Tracking Antenna (Nolan, Hardy, Michael)
@Nolan Haines @Hardy Yu @Michael Botros
Schematic basically finished, replaced connector schematic and cleaned up schematic a bit
Schematic review soon
12S Servo Module (Jerry)
@Jerry Tian
Added ground plane, via stitching and signed my name . Layout is under review (final one hopefully)
Farris and Daniel will review.
Plan to order with tracking antenna
ZP3 Rework (Anthony, Ryan)
@Anthony Zhelnakov @Ryan Scomazzon
@Daniel Puratich stated all of the project requirements. We’ve listed them here: ZP3 Flight Interface Board - Electrical - WARG (atlassian.net)
Asked EFS for any sensors/peripherals they want added to the new flight interface board. Waiting on reply. Plz document.
Capacitor Analysis for Drone (Anthony)
@Anthony Zhelnakov
Meet today with @Daniel Puratich to go over requirements to kick off.